View Full Version : Stevens 200 build (firing pin question)
I am converting a Stevens 200 .270 into a 300 win mag. I purchased the mag. bolt head and all other parts needed. Here is the question, do I need to adjust the firing pin protrusion after I install the mag. bolt head?
joeb33050
06-02-2012, 01:49 PM
You need to CHECK, and ADJUST if necessary.
PM me if you need instructions.
joe b.
I just did the same bolt head swap on a Stevens, I didn't have to adjust mine but it was close to max length.
Bob
Toyoda
06-03-2012, 11:33 AM
Joeb33050-I would like the instructions. I can't PM you :'(
joeb33050
06-03-2012, 03:03 PM
Joeb33050-I would like the instructions. I can't PM you :'(
Send me your email address and I'll send it/them
joeb33050@yahoo.com
joe b.
klayton83
06-03-2012, 10:28 PM
i think that when savage sends out a factory rifle it is a good thing to just go ahead and check the protrusion and adjust since it is such an easy process, just to make sure.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.