View Full Version : go gauge only headspace
stewart33
09-20-2012, 02:24 AM
two layers of scotch tape and bolt starts to cam over but won't close. little loose?
kschilling
09-20-2012, 03:52 PM
I only use one layer of tape when I reset the headspace on all barrels.... even factory.
JackinSD
09-20-2012, 04:15 PM
I only use one layer of tape when I reset the headspace on all barrels.... even factory.
Same same here.
pdog06
09-20-2012, 05:19 PM
the difference between a go and a no-go is .004", so measure the go gauge, then add tape until the go gauge measures .004" longer and you will be fine.
It really depends on the brand of tape. I have used some that needed 1 layer and some that have needed 2 layers.
BoilerUP
09-20-2012, 08:08 PM
One piece of Scotch brand tape and GTG...
stewart33
09-21-2012, 12:23 AM
I couldn't remember if it was one or two layers of scotch brand tape. I'll measure it regardless.
thanx, Ted
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.