View Full Version : Will it work?
Redandwhite_72
12-18-2013, 11:09 AM
I have a 110 with top bolt release and a blind mag. I have located a detachable mag setup from a 116 but it was with a bottom bolt release. Will it work on my 110?
I think you will have to change your sear. I assume the "set up" includes the stock.
Redandwhite_72
12-18-2013, 11:40 AM
Yes it comes with the stock too.
Then I think the sear is your only hurdle.
Redandwhite_72
12-18-2013, 12:41 PM
OK. Thanks
sharpshooter
12-18-2013, 08:08 PM
The sear has nothing to do with the DBM. Use your original top bolt release. The only thing you will have to do is add shim washer under your trigger guard to bring it up to height.
Redandwhite_72
12-18-2013, 08:11 PM
Thanks sharpshooter. That sounds a lot better.
Sorry, I assumed you were using the bottom bolt release. :confused:
Redandwhite_72
12-18-2013, 08:46 PM
Rp12. No worries. I should have been more clear in my original post.
sharpshooter
12-18-2013, 09:36 PM
The sears will not interchange on the two, regardless.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.