CAPTBEACH
10-03-2014, 08:55 PM
Out in the shop reassembling the bolt...I notice that the new PTG bolt does not have the U shaped alignment groove on the extractor side of the bolt shaft...did they miss something in the machining?
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG1_zps64dd738f.jpg
I notice there is a notch punched into the bolt body for this to slip into...do people grind out this notch so the bolt shaft slides in?
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG2_zpsbb861061.jpg
And the new bolt knob...metal is so yesterday...
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG3BH_zpsf93de028.jpg
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG1_zps64dd738f.jpg
I notice there is a notch punched into the bolt body for this to slip into...do people grind out this notch so the bolt shaft slides in?
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG2_zpsbb861061.jpg
And the new bolt knob...metal is so yesterday...
http://i1144.photobucket.com/albums/o496/CAPTBEACH/PTG3BH_zpsf93de028.jpg