Deadshot2
06-10-2017, 08:40 AM
A bit off target (?) but how does everyone use or set up their BS?? How do you keep the BS rod off the bore/lands, etc., I realize the BS has it's own guide and it works pretty good, but how do you handle the rest of the rod to keep it lined up with the bore. Trying to look at the small view screen and control the BS rod can be a bit challenging at times (to me anyways) :confused:
i haven't found it to be a problem with the wand just floating in the barrel. I manipulate it with the handle end to get the best view and then just "snap" the picture I want.
If you get an assortment of small O-rings of different thickness just put a couple on the want at intervals so as you insert it there will be more and more centering support. Make the ID the same as he wand and the thickness a little less than 1/2 the difference between wand diameter and bore diameter of the barrel. The wand is pretty much "right sized" for any .22 cal barrel.
i haven't found it to be a problem with the wand just floating in the barrel. I manipulate it with the handle end to get the best view and then just "snap" the picture I want.
If you get an assortment of small O-rings of different thickness just put a couple on the want at intervals so as you insert it there will be more and more centering support. Make the ID the same as he wand and the thickness a little less than 1/2 the difference between wand diameter and bore diameter of the barrel. The wand is pretty much "right sized" for any .22 cal barrel.