patrickk83
08-04-2017, 12:49 PM
Hello and greetings from Austria!
After reading a lot about torquing the Savage Accustock I realized that the screws of the rail scope mount become loose.
Could someone plese tell me how much in.-lbs. I should use for tightening the screws. I think I will use blue or red Loctite too.
The rail is the standard one which came with the rifle (I think it's a 0MOA rail but I don't know how to figure it out).
For the Accustock I applied 35 in-lbs at the front screw and 30 in-lbs at the back screw. Any other helpful suggestions are welcome.
Thank you for your help
best regards
Patrick
After reading a lot about torquing the Savage Accustock I realized that the screws of the rail scope mount become loose.
Could someone plese tell me how much in.-lbs. I should use for tightening the screws. I think I will use blue or red Loctite too.
The rail is the standard one which came with the rifle (I think it's a 0MOA rail but I don't know how to figure it out).
For the Accustock I applied 35 in-lbs at the front screw and 30 in-lbs at the back screw. Any other helpful suggestions are welcome.
Thank you for your help
best regards
Patrick