View Full Version : Mark I/II/93R: Mark II bolt problem
I have a new Savage MK II I believe it is the longer E receiver and when closing the bolt without a round it stops about a quarter inch from full closing and I have to give it a good push to close. Anyone have any thoughts on what could be wrong ? It is the stainless bull barrrel with thumb hole stock.
could this be due to adjusting the trigger ?
lee1000
09-16-2019, 10:54 PM
Is the magazine getting in the way?
Sounds like a call to Savage is in order.
it does it with or without the magazine in. I am going to call savage today
There was a piece broken out of the guide pin that was causeing the problems. I put in a new guide pin and no more problems
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.