View Full Version : Model 112 Feed problem
Prairie Dog hunter
06-30-2021, 02:42 PM
I have a Mod 112, cal Rem 22-250. 2nd Round jumps out of magazine too high and will not feed. Causes jam....3 and 4 remain normal
243winxb
06-30-2021, 04:52 PM
Make sure all cartridges are fully seated to the rear of the magazine. Or load only 3 rounds. If this doesnt help, >>
I would bend the magazine lips in a tiny amount. Think thousandths. Before starting, take measurement from lip to lip. This is where the cartridges sIts.
I measure with an RCBS dial caliper.
This Youtube guy is bending lips out. You want to bend them in.
https://youtu.be/eDqBlqpdxCI
Robinhood
06-30-2021, 05:15 PM
Someone deleted my earlier thread here.
You can tell a lot by moving the bolt slowly and watching what happens. With that knowledge you can apply the suggestion above with a greater purpose.
Prairie Dog hunter
06-30-2021, 05:45 PM
I have a Mod 112, cal Rem 22-250. 2nd Round jumps out of magazine too high and will not feed. Causes jam....3 and 4 remain normal
Thanks guys, I am reminded of a similar problem with one of my Mod 11's a couple years ago......yes, I bent the lips a tad and problem was resolved. I wanted a warm and fuzzy that
I was doing the right thing. I shall attempt another fix
want2ride
06-30-2021, 08:39 PM
I have a kimber 7mm-08 that has an internal box mag that feeds the first one perfect and the second one is always too low, but feeds the third one just fine. I am hoping that i can adjust that as easy as my AICS mags. With the AICS mags that feed lip adjustment tool makes it SOOO easy. If you don't have one get the tool!!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.