tomme boy
06-14-2022, 12:46 AM
My 223 was blanking primers bad. So i sent in the barreled action to savage and they POLISHED the bolthead. Well they replaced the bolthead and firing pin. I marked both of them as I have seen this before from them.
Then a whole new problem started. Misfires non stop. I measured the protrusion and it was about 0.25". So I took out the firing pin and put it in the lathe and faced the shoulder or whatever its called on the new 2 piece pin. Have not had any problems since.
Then a whole new problem started. Misfires non stop. I measured the protrusion and it was about 0.25". So I took out the firing pin and put it in the lathe and faced the shoulder or whatever its called on the new 2 piece pin. Have not had any problems since.