zeegadget
11-30-2010, 02:13 PM
I spent a lot of time yesterday trying to fit a B & C Tactical Medalist to my Savage/Stevens 4.40 screw
spacing, CENTER FEED. The problem was where the small metal piece that holds the blind magazine down
sets at where the rear screw comes up to meet the receiver. The aluminium frame is not milled down
enough and in trun will not let the receiver bed into the stock. I used a Dremal tool and a file and it took
a while to trim that area down. That aluminium is a lot harder than I thought it would be.
I got "R" done and also let B & C know about the problem.
Tom
SW Pennsylvania
spacing, CENTER FEED. The problem was where the small metal piece that holds the blind magazine down
sets at where the rear screw comes up to meet the receiver. The aluminium frame is not milled down
enough and in trun will not let the receiver bed into the stock. I used a Dremal tool and a file and it took
a while to trim that area down. That aluminium is a lot harder than I thought it would be.
I got "R" done and also let B & C know about the problem.
Tom
SW Pennsylvania