View Full Version : Assembling a bolt head from parts?
BoilerUP
01-18-2011, 05:33 PM
What parts (other than a stripped bolt head) are necessary if one wants to "build" a complete bolt head from parts?
Thinking of converting a 7mm Rem Mag 110 to a .473 caliber, but I'd want to keep the magnum bolt head intact.
thirty06
01-18-2011, 05:52 PM
You need 6 more parts,
ejector extractor
ejector spring extractor spring
ejector pin extractor ball bearing
Not sure if that's the official names or not but Midway carries them.
BoilerUP
02-15-2011, 09:57 PM
Changed my mind....
If I bought a stripped .473 long action right eject bolt face, can I use all the parts from my magnum bolt face?
GaCop
02-16-2011, 06:48 AM
Is the magnum BH a controlled round feed? If so, not interchangable.
BoilerUP
02-16-2011, 07:53 AM
Is the magnum BH a controlled round feed? If so, not interchangable.
I *believe* it is push feed (7mm Rem Mag), but I'm on the road on business and can't look at it.
jglover_81
02-16-2011, 11:06 AM
The only problem I can think of is getting the ejector retaining pin out without damaging it..... it will take a 1/16" pin punch which is not too easy to find..... other than that I swapped the extracter parts from my .473 to my magnum and am waiting on midway to get the pins back in stock
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.