View Full Version : removing trigger group
druid w/stick
03-19-2011, 09:32 PM
Have model 12 with accutrigger. Was bought used and was spray painted. Want to redo, plus do a bedding job. Can complete trigger assembly be removed
without taking apart in pieces? If so, how does one go about doing this?
Greg
trappst
03-19-2011, 09:47 PM
Push the cross pin out that holds the trigger bracket and sear. Just keep a finger or something over the sear spring as they have a nasty habit of flying off into infinity.
Re-assembly can be a bit tricky but nothing terrible.
druid w/stick
03-19-2011, 09:55 PM
Thanks Trappst. I had read something like that here before , was'nt quite sure . Thanks for quick reply.
Greg
MDHOGGER
03-20-2011, 08:42 PM
Another tip would to get yourself a small punch the same diameter or less than the cross pin to use as a slave. Insert it first through the trigger housing and then follow it back out with the cross pin. This will help in keeping things in alignment.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.